====== Pripajanie sa na mijolu prostrednictvom konzoly ======

===== Linux =====

Pripoji sa konzola ku mijole (ci uz usb -> konzola prevodnik, alebo seriak -> konzola prevodnik).
Na PC sa nainstaluje minicom
<code>
sudo apt-get install minicom
</code>
spusti sa minicom:
<code>
minicom -o
</code>
nastavi sa minicom aby bolo nastavene: 38400 8N1, bez HW flow control. Postupnost prikazov pre nastavenie je:
Ctrl+A Z, potom O. Tabulka ma vypadat takto v pripade USB prevodnika (podla jeho cisla ziskaneho z prikazu dmesg):
<code>
+-----------------------------------------------------------------------+
| A -    Serial Device      : /dev/ttyUSB0                              |
| B - Lockfile Location     : /var/lock                                 |
| C -   Callin Program      :                                           |
| D -  Callout Program      :                                           |
| E -    Bps/Par/Bits       : 38400 8N1                                 |
| F - Hardware Flow Control : No                                        |
| G - Software Flow Control : No                                        |
|                                                                       |
|    Change which setting?                                              |
+-----------------------------------------------------------------------+
</code>
a nejako takto v pripade priameho seriaku v pripade prveho portu:
<code>
+-----------------------------------------------------------------------+
| A -    Serial Device      : /dev/ttyS0                                |
| B - Lockfile Location     : /var/lock                                 |
| C -   Callin Program      :                                           |
| D -  Callout Program      :                                           |
| E -    Bps/Par/Bits       : 38400 8N1                                 |
| F - Hardware Flow Control : No                                        |
| G - Software Flow Control : No                                        |
|                                                                       |
|    Change which setting?                                              |
+-----------------------------------------------------------------------+
</code>
Po ulozeni a pripojeni by sa mala zobrazit poziadavka na prihlasenie podobne ako cez ssh.

===== Windows =====

Prosim kto vie nech dopise :-)